Debug Etherchannel - Dell Catalyst 3130 Command Reference Manual

Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands

debug etherchannel

Use the debug etherchannel privileged EXEC command to enable debugging of the
EtherChannel/PAgP shim. This shim is the software module that is the interface between the Port
Aggregation Protocol (PAgP) software module and the port manager software module. Use the no form
of this command to disable debugging.
Syntax Description all
detail
error
event
idb
Note Though visible in the command-line help strings, the linecard keyword is not supported.
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines If you do not specify a keyword, all debug messages appear.
The undebug etherchannel command is the same as the no debug etherchannel command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
show etherchannel
OL-13271-03
debug etherchannel [all | detail | error | event | idb]
no debug etherchannel [all | detail | error | event | idb]
(Optional) Display all EtherChannel debug messages.
(Optional) Display detailed EtherChannel debug messages.
(Optional) Display EtherChannel error debug messages.
(Optional) Debug major EtherChannel event messages.
(Optional) Display PAgP interface descriptor block debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays EtherChannel information for the channel.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
debug etherchannel
B-9