Mls Qos Srr-Queue Input Dscp-Map - Dell Catalyst 3130 Command Reference Manual

mls qos srr-queue input dscp-map

mls qos srr-queue input dscp-map
Use the mls qos srr-queue input dscp-map global configuration command on the switch stack or on a
standalone switch to map Differentiated Services Code Point (DSCP) values to an ingress queue or to
map DSCP values to a queue and to a threshold ID. Use the no form of this command to return to the
default setting.
Syntax Description queue queue-id
dscp1...dscp8
threshold threshold-id
dscp1...dscp8
Defaults
Table 2-11
Table 2-11
DSCP Value
0–39
40–47
48–63
Command Modes
Global configuration
Command History Release
12.2(40)EX1
Usage Guidelines The DSCP assigned at the ingress port selects an ingress or egress queue and threshold.
The drop-threshold percentage for threshold 3 is predefined. It is set to the queue-full state. You can
assign two weighted tail-drop (WTD) threshold percentages to an ingress queue by using the mls qos
srr-queue input threshold global configuration command.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
2-350
mls qos srr-queue input dscp-map queue queue-id {dscp1...dscp8 | threshold threshold-id
dscp1...dscp8}
no mls qos srr-queue input dscp-map
Specify a queue number.
For queue-id, the range is 1 to 2.
Map DSCP values to an ingress queue.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
Map DSCP values to a queue threshold ID.
For threshold-id, the range is 1 to 3.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
shows the default DSCP input queue threshold map:
Default DSCP Input Queue Threshold Map
Queue ID–Threshold ID
1–1
2–1
1–1
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
OL-13271-03