Dell Catalyst 3130 Command Reference Manual page 208

interface port-channel
Follow these guidelines when you use the interface port-channel command:
•
•
For a complete list of configuration guidelines, see the "Configuring EtherChannels" chapter in the
software configuration guide for this release.
Examples
This example shows how to create a port-channel interface with a port channel number of 5:
Switch(config)# interface port-channel 5
You can verify your setting by entering the show running-config privileged EXEC or show
etherchannel channel-group-number detail privileged EXEC command.
Related Commands Command
channel-group
show etherchannel
show running-config
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
2-178
If you want to use the Cisco Discovery Protocol (CDP), you must configure it only on the physical
port and not on the port-channel interface.
Do not configure a port that is an active member of an EtherChannel as an IEEE 802.1x port. If
IEEE 802.1x is enabled on a not-yet active port of an EtherChannel, the port does not join the
EtherChannel.
Description
Assigns an Ethernet port to an EtherChannel group.
Displays EtherChannel information for a channel.
Displays the operating configuration. For syntax information, use this link
to the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command
_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
OL-13271-03