Switch - Dell Catalyst 3130 Command Reference Manual

switch

switch
Use the switch privileged EXEC on a stack member to disable or enable the specified stack port on the
member.
Note This command is supported only on stacking-capable switches.
Syntax Description stack-member-number
stack port port-number
disable
enable
Defaults The stack port is enabled.
Command Modes
Privileged EXEC
Command History Release
12.2(50)SE
Usage Guidelines
Be careful when using the switch stack-member-number stack port port-number disable command.
Note
When you disable the stack port, the stack operates at half or full bandwidth .
A stack is in the full-ring state when all members are connected through the stack ports and are in the
ready state.
The stack is in the partial-ring state when
•
•
If you enter the switch stack-member-number stack port port-number disable privileged EXEC
command and
•
•
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-762
switch stack-member-number stack port port-number {disable | enable}
Modification
This command was introduced.
All members are connected through their stack ports, but some are not in the ready state.
Some members are not connected through the stack ports.
The stack is in the full-ring state, you can disable only one stack port. This message appears:
Enabling/disabling a stack port may cause undesired stack changes. Continue?[confirm]
The stack is in the partial-ring state, you cannot disable the port. This message appears:
Disabling stack port not allowed with current stack configuration.
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
Specify the current stack member number. The range is 1 to 9.
Specify the stack port on the member. The range is 1 to 2.
Disable the specfied port.
Enable the specified port.
OL-12248-03