Dell Catalyst 3130 Command Reference Manual page 693

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
This is an example of output from the show storm-control command for a specified interface. Because
no traffic-type keyword was entered, the broadcast storm control settings appear.
Switch> show storm-control gigabitethernet 1/0/1
Interface
---------
Gi1/0/1
Table 2-33
Table 2-33
Field
Interface
Filter State
Upper
Lower
Current
Related Commands Command
storm-control
OL-12248-03
Filter State Upper
------------- ----------
Forwarding 20 pps
describes the fields in the show storm-control display.
show storm-control Field Descriptions
Description
Displays the ID of the interface.
Displays the status of the filter:
Blocking—Storm control is enabled, and a storm has occurred.
•
• Forwarding—Storm control is enabled, and no storms have occurred.
• Inactive—Storm control is disabled.
Displays the rising suppression level as a percentage of total available
bandwidth in packets per second or in bits per second.
Displays the falling suppression level as a percentage of total available
bandwidth in packets per second or in bits per second.
Displays the bandwidth usage of broadcast traffic or the specified traffic
type (broadcast, multicast, or unicast) as a percentage of total available
bandwidth. This field is only valid when storm control is enabled.
Description
Sets the broadcast, multicast, or unicast storm control levels for the switch.
Lower Current
--------- ---------
10 pps 5 pps
Cisco Catalyst Blade Switch 3120 for HP Command Reference
show storm-control
2-663