Dell Catalyst 3130 Command Reference Manual page 544

show interfaces
transceiver
[detail |
properties]
trunk
| begin
| exclude
| include
expression
Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
Note
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes
Privileged EXEC
Command History Release
12.2(46)SE
12.2(40)EX1
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
•
•
•
•
•
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-514
(Optional) Display the physical properties of a coarse wavelength-division
multiplexer (CWDM) or dense wavelength-division multiplexer (DWDM) small
form-factor (SFP) module interface. The keywords have these meanings:
detail—(Optional) Display calibration properties, including high and low
•
numbers and any alarm information.
properties—(Optional) Display speed, duplex, and inline power settings on
•
an interface.
Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
The tengigabitethernet interface-id transceiver detail keywords were
added.
This command was introduced.
se the show interface capabilities module number command to display the capabilities of all
interfaces on that switch in the stack. If there is no switch with that module number in the stack,
there is no output.
se the show interface capabilities module 1 command to display the capabilities of all interfaces
on the switch. Any other number is invalid.
Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
se the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces in the stack.
se the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces on the switch.
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
OL-12248-03