Dell Catalyst 3130 Command Reference Manual page 725

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
pim
[invalid-pim-message |
neighbor-change |
rp-mapping-change]
port-security
[trap-rate value]
rtr
snmp [authentication |
coldstart | linkdown |
linkup | warmstart]
storm-control
trap-rate value
stpx
syslog
tty
vlan-membership
vlancreate
vlandelete
vtp
Note Though visible in the command-line help strings, the fru-ctrl, insertion, and removal keywords are not
supported on nonstacking-capable switches. The snmp-server enable informs global configuration
command is not supported. To enable the sending of SNMP inform notifications, use the snmp-server
enable traps global configuration command combined with the snmp-server host host-addr informs
global configuration command.
OL-12248-03
(Optional) Enable Protocol-Independent Multicast (PIM) traps. The
keywords have these meanings:
invalid-pim-message—(Optional) Enable invalid PIM message traps.
•
neighbor-change—(Optional) Enable PIM neighbor-change traps.
•
rp-mapping-change—(Optional) Enable rendezvous point
•
(RP)-mapping change traps.
(Optional) Enable port security traps. Use the trap-rate keyword to set the
maximum number of port-security traps sent per second. The range is from
0 to 1000; the default is 0 (no limit imposed; a trap is sent at every
occurrence).
(Optional) Enable SNMP Response Time Reporter traps.
(Optional) Enable SNMP traps. The keywords have these meanings:
authentication—(Optional) Enable authentication trap.
•
coldstart—(Optional) Enable cold start trap.
•
linkdown—(Optional) Enable linkdown trap.
•
linkup—(Optional) Enable linkup trap.
•
• warmstart—(Optional) Enable warmstart trap.
(Optional) Enable storm-control traps. Use the trap-rate keyword to set the
maximum number of storm-control traps sent per minute. The range is 0 to
1000; the default is 0 (no limit is imposed; a trap is sent at every occurrence).
(Optional) Enable SNMP STPX MIB traps. The keywords have these
meanings:
inconsistency—(Optional) Enable SNMP STPX MIB Inconsistency
•
Update traps.
root-inconsistency—(Optional) Enable SNMP STPX MIB Root
•
Inconsistency Update traps.
loop-inconsistency—(Optional) Enable SNMP STPX MIB Loop
•
Inconsistency Update traps.
(Optional) Enable SNMP syslog traps.
(Optional) Send TCP connection traps. This is enabled by default.
(Optional) Enable SNMP VLAN membership traps.
(Optional) Enable SNMP VLAN-created traps.
(Optional) Enable SNMP VLAN-deleted traps.
(Optional) Enable VLAN Trunking Protocol (VTP) traps.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
snmp-server enable traps
2-695