Debug Nmsp - Dell Catalyst 3130 Command Reference Manual

debug nmsp

debug nmsp
Use the debug nmsp privileged EXEC command to the enable debugging of the Network Mobility
Services Protocol (NMSP) on the switch. This command is available only when your switch is running
the cryptographic (encrypted) software image. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(50)SE
Usage Guidelines
The undebug nmsp command is the same as the no debug nmsp command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
show nmsp
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
B-24
debug nmsp {all | connection | error | event | packet | rx | tx}
no debug nmsp
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays the NMSP information.
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
OL-13271-03