Dell Catalyst 3130 Command Reference Manual page 68

authentication port-control
•
To globally disable IEEE 802.1x authentication on the switch, use the no dot1x system-auth-control
global configuration command. To disable IEEE 802.1x authentication on a specific port or to return to
the default setting, use the no authentication port-control interface configuration command.
Examples This example shows how to set the port state to automatic:
Switch(config)# authentication port-control auto
This example shows how to set the port state to the force- authorized state:
Switch(config)# authentication port-control force-authorized
This example shows how to set the port state to the force-unauthorized state:
Switch(config)# authentication port-control force-unauthorized
You can verify your settings by entering the show authentication privileged EXEC command.
Related Commands Command
authentication
control-direction
authentication event
authentication
fallback
authentication
host-mode
authentication open
authentication order
authentication
periodic
authentication
priority
authentication timer
authentication
violation
show authentication
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
2-38
Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) destination ports—You can enable
IEEE 802.1x authentication on a port that is a SPAN or RSPAN destination port. However, IEEE
802.1x authentication is disabled until the port is removed as a SPAN or RSPAN destination. You
can enable IEEE 802.1x authentication on a SPAN or RSPAN source port.
Description
Configures the port mode as unidirectional or bidirectional.
Sets the action for specific authentication events.
Configures a port to use web authentication as a fallback method for clients
that do not support IEEE 802.1x authentication.
Sets the authorization manager mode on a port.
Enables or disables open access on a port.
Sets the order of the authentication methods used on a port.
Enables or disable reauthentication on a port.
Adds an authentication method to the port-priority list.
Configures the timeout and reauthentication parameters for an
802.1x-enabled port.
Configures the violation modes that occur when a new device connects to a
port or when a new device connects to a port after the maximum number of
devices are connected to that port.
Displays information about authentication manager events on the switch.
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
OL-13271-03