Debug Platform Ip Wccp - Dell Catalyst 3130 Command Reference Manual

Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands

debug platform ip wccp

Use the debug platform ip wccp privileged EXEC command to enable debugging of Web Cache
Communication Protocol (WCCP). Use the no form of this command to disable debugging.
This command is supported only if your switch is running the IP services feature set.
Syntax Description acl
event
odm
trace
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug platform ip wccp command is the same as the no debug platform ip wccp command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
OL-13271-03
debug platform ip wccp {acl | event | odm | trace}
no debug platform ip wccp {acl | event | odm | trace}
Display WCCP access control lists (ACLs).
Display WCCP event debug messages.
Display WCCP OD merge VMRs.
Trace WCCP execution.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are
enabled.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
debug platform ip wccp
B-47