Dell Catalyst 3130 Command Reference Manual page 958

debug platform ip igmp snooping
rpc [cfg | l3mm | misc
| vlan]
warn
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug platform ip igmp snooping command is the same as the no debug platform ip igmp
snooping command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
debug ip igmp
snooping
show debugging
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
B-42
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
Display IGMP snooping remote procedure call (RPC) event debug messages.
The keywords have these meanings:
cfg—(Optional) Display IGMP snooping RPC debug messages.
•
l3mm—(Optional) IGMP snooping Layer 3 multicast router group RPC
•
debug messages.
misc—(Optional) IGMP snooping miscellaneous RPC debug messages.
•
vlan—(Optional) IGMP snooping VLAN assert RPC debug messages.
•
Display IGMP snooping warning messages.
Modification
This command was introduced.
Description
Displays information about platform-independent IGMP snooping activity.
Displays information about the types of debugging that are enabled.
OL-13271-03