Table of Contents
Advertisement
Chapter 2
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
reload
Use the reload privileged EXEC command to reload the stack member and to put a configuration change
into effect.
Note
This command is supported only on stacking-capable switches.
Syntax Description
LINE
at
cancel
in
slot stack-member-number
standby-cpu
Defaults
Immediately reloads the stack member and puts a configuration change into effect.
Command Modes
Privilege EXEC
Command History
Release
12.2(40)EX1
Usage Guidelines
If there is more than one switch in the switch stack, and you enter the reload slot stack-member-number
command, you are not prompted to save the configuration.
Examples
This example shows how to reload the switch stack:
Switch(config)# reload
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
This example shows how to reload a specific stack member:
Switch(config)# reload slot 6
Proceed with reload? [confirm] y
This example shows how to reload a single-switch switch stack (there is only one member switch):
Switch(config)# reload slot 3
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
OL-13271-03
reload [LINE | at | cancel | in | slot stack-member-number | standby-cpu]
Modification
This command was introduced.
Specify the reason for the reload.
Specify the time in hh:mm for the reload to occur.
Cancel the pending reload.
Specify a time interval in mmm or hhh:mm for reloads to occur.
Save the changes on the specified stack member and restart it.
Reload the standby route processor (RP).
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
reload
2-415
Advertisement
Table of Contents
