Authentication Fallback - Dell Catalyst 3130 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands

authentication fallback

Use the authentication fallback interface configuration command to configure a port to use web
authentication as a fallback method for clients that do not support IEEE 802.1x authentication. To return
to the default setting, use the no form of this command.
Syntax Description
name
Defaults
No fallback is enabled.
Command Modes Interface configuration
Command History Release
12.2(50)SE
Usage Guidelines You must enter the authentication port-control auto interface configuration command before
configuring a fallback method.
You can only configure web authentication as a fallback method to 802.1x or MAB, so one or both of
these authentication methods should be configured for the fallback to enable.
Examples
This example shows how to specify a fallback profile on a port:
Switch(config)# authentication fallback profile1
You can verify your settings by entering the show authentication privileged EXEC command.
Related Commands Command
authentication
control-direction
authentication event
authentication
host-mode
authentication open
authentication order
authentication
periodic
OL-13271-03
authentication fallback name
no authentication fallback name
Specify a web authentication fallback profile.
Modification
This command was introduced.
Description
Configures the port mode as unidirectional or bidirectional.
Sets the action for specific authentication events.
Sets the authorization manager mode on a port.
Enables or disable open access on a port.
Sets the order of authentication methods used on a port.
Enables or disables reauthentication on a port.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
authentication fallback
2-27