Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 892

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Common Administrative Procedures
Night Service
Console Procedure To add or change start/stop time:
PC Procedure
Night Service with Coverage Control
Use this procedure to enable or disable the Night Service Coverage Control
option to automatically control the status of programmed Coverage VMS Off
buttons.
When the Coverage Control option is enabled, a transition into Night Service
(either by pressing a Night Service button or automatically by the Time Set
option) automatically deactivates the VMS Coverage Off (Release 2.0 or later)
buttons (LED is off) and allows outside calls to go to VMS Coverage at night.
When the system is taken out of Night Service (either by pressing a Night
Service button or automatically by the Time Set option), programmed VMS
Coverage Off buttons are activated (LED is on) and outside calls are prevented
from going to VMS Coverage during the day.
When the Coverage Control option is disabled, Night Service status has no effect
on programmed VMS Coverage Off buttons.
Summary: Night Service with Coverage Control
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Drop
To activate/deactivate:
 È U
I
To add or change start/stop time:
É U
I
+
+ Type stop day and time
  Ã Ä  Ç
To activate/deactivate:
or
System Manager
All
Not required
Form 9c, Night Service: Options
Disabled
Enable or Disable
No
No
  Ã Ä  Ç
or
Drop Dial start day and time
Dial stop day and time
or
Type start day and time
4
4
or
Issue 1
February 1998
Page 4-422

 Ç