Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 655

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
PRI Facilities
Copy Telephone Number to Send
Use this procedure to indicate whether or not the telephone number to send to the
network (for calls going out over ISDN lines assigned to a B-channel group) is
copied from the number assigned to that channel.
NOTE: NOTE: NOTE:
In Release 6.0 and later systems (Hybrid/PBX mode only), setting the
switch type to Legend-PBX or Legend-Ntwk automatically assigns Copy
Number as the option for the single B-channel group associated with PRI
tandem trunk that you specified in the Switch Type setting. As long as the
switch type for the slot is set this way, you cannot change the Copy
programming. For more information about switch types, see
on page
Select
assigned to each channel in the B-channel group or when no telephone number is
to be sent to the network. In the latter case, make sure that no telephone numbers
are assigned to any channels in the B-channel group by using the "Telephone
Number to Send" procedure.
Summary: Copy Telephone Number to Send
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
4–166.
System Manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)
Do Not Copy
Do Not Copy, Copy
No
No
Dial group no.
Æ È Ä Æ
Specify copy or no copy
4
either when a telephone number to send is
4
Specify copy or no copy
 Ç Ç Ç
Type group no.
Issue 1
February 1998
Page 4-185
"Switch Type"