E&M Signal - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
Tie Trunks
E&M Signal
Use this procedure to specify the type of tie trunk signal, as follows:
E&M Mode:
Simplex Mode:
NOTE: NOTE: NOTE:
In Release 6.0 and later systems, E&M trunks that are used for networking
should be programmed at each end with a switch identifier that indicates
the remote system where the trunk is connected. See
Facilities" on page 4–82
Summary: E&M Signal
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
— 1S, Type 1 Standard. Tie trunks that are connected through the
local telephone company.
— 1C, Type 1 Compatible. Tie trunks that are connected directly to a
system that uses 1S signaling.
— 5, Type 5 Simplex. Tie trunks that are connected to a system using
Type 5 signaling.
System Manager
All
Tie trunk idle
Form 3c, Incoming Trunks: Tie
1S
1S, 1C, 5
No
Yes
Æ Ä Æ
Specify signaling type
 Ç Ç
type
4
for details.
4
Type trunk no.
Issue 1
February 1998
Page 4-127
"Uniform Dial Plan
Dial trunk no.

Specify signaling