Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 658

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
PRI Facilities
Incoming Routing
Use this procedure to specify whether incoming routing is either by line
appearance or according to dial plan. Dial Plan Routing is available in Hybrid/PBX
mode only.
In Release 6.0 and later systems, the Incoming Routing screen displays an
option, Route Directly to UDP (Uniform Dial Plan). In Release 6.0 and later
systems, setting the switch type to Legend-PBX or Legend-NTWK automatically
assigns Route Directly to UDP as the Incoming Routing option for the single
B-channel group associated with the Switch Type setting. As long as the switch
type for the slot of the PRI tandem trunk is set this way, you cannot change the
incoming routing for the group. This routing option cannot be selected for any
other switch type. For more information about switch types, see
page 4–166.
Summary: Incoming Routing
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System Manager
Line appearance: Hybrid/PBX, Key; Dial Plan Routing or
Route Directly to UDP: Hybrid/PBX only
Not required
Form 3b, Incoming Trunks: DS1 Connectivity (100D module)
Line appearance
Dial Plan Routing, Routing by Line Appearance,
Route Directly to UDP
No
No
B-channel group no.
Æ È Ä È
method

Specify routing method
4
"Switch Type" on
4
Specify routing
 Ç Ç Ç
Type B-channel group no.
Issue 1
February 1998
Page 4-188
Dial