Did Trunks; Block Assignment - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures

DID Trunks

DID Trunks
This section covers programming DID trunks and includes procedures for the
following:

Block Assignment

DID Trunk Type
Disconnect Time
Expected Digits
Delete Digits
Add Digits
Signaling
Invalid Destination
NOTE: NOTE: NOTE:
These procedures apply to Hybrid/PBX mode only.
Block Assignment
Use this procedure to assign each DID trunk connected to the system to either
Block 1 or Block 2.
Summary: Block Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
System Manager
Hybrid/PBX
Not required
Form 3d, Incoming Trunks: DID
Block 1
Block 1, Block 2
Yes
Yes
4
4
4
Issue 1
February 1998
Page 4-143