Programming Analog Multiline Telephones; Programming Mlx-10 And Mlx-5 Nondisplay Telephones - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
D General Feature Use and Telephone Programming
Telephone Programming
Table D–2. Programming Analog Multiline Telephones
Step
1 Label the button.
Note: Skip this step if the feature
is not programmed on a button.
2 Begin programming.
3 Select the feature or setting.
4 End programming.
Table D–3. Programming MLX-10 and MLX-5 Nondisplay Telephones
Step
1 Label the button.
Note: Skip this step if the feature
will not be programmed onto a
button.
2 Begin programming.
3 Select the feature or setting.
4 End programming.
Action
Remove the clear label cover from the phone: insert
the end of a paper clip in the notch at the top of the
cover.
Write the feature name on the card next to the
button to be programmed.
Replace the cover.
Slide the T/P switch on the side of the phone to P.
Press the button you labeled.
If you have a display phone, it shows the name of
the feature currently programmed on the button. If
no feature is programmed, the display indicates that
the button is blank.
Note: If the feature does not get programmed onto a
button, press any line button. This does not affect
the button in any way.
Dial the programming code.
The feature is programmed.
Slide the T/P switch to the center position.
Action
Remove the clear label cover from the phone: pull
up on the tab that extends from the top of the cover.
Write the feature name on the card next to the
button to be programmed.
Replace the cover.
Press the Feature button and then dial
Press the button you labeled.
Note: If the feature is programmed onto a button,
press any line button. This does not affect the button
in any way.
Dial the programming code.
The feature is programmed.
Press the Feature button and dial
Issue 1
February 1998
Page D-13
.
.