Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 726

Communications system
Hide thumbs Also See for MERLIN LEGEND Release 6.0:
Table of Contents

Advertisement

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4
Common Administrative Procedures
Extensions
Each System Access Ring or Voice on an individual telephone can be
assigned as a Shared System Access (SSA) button on up to 16 other
extensions.
Shared SA buttons cannot be assigned to single-line telephones or other
tip/ring equipment connected to an 016, 012, or 008 OPT module. Shared
SA buttons can be assigned to a tip/ring or external alert device connected
to an MFM in an MLX telephone or a GPA connect to an analog multiline
telephone. Shared SA buttons cannot be assigned when the corresponding
SA button is on a single-line set.
Release 3.0 and later
Each System Access Ring or Voice on an individual extension can be
assigned as a Shared System Access (SSA) button on up to 27 other
extensions.
System Access and Intercom buttons are centrally programmed and cannot
be programmed by individual extension users.
Summary: Assign Intercom or System Access
Buttons
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
System Manager
All, but note differences in factory settings
Extension idle
Form 4b, Analog Multiline Telephone
Form 4d, MLX Telephone
Form 4e, MFM Adjuncts: MLX Telephone
Form 4f, Tip/Ring Equipment
Form 5a, Direct-Line Console (DLC): Analog
Form 5b, Direct-Line Console (DLC): Digital
Form 5c, MFM Adjunct (DLC)
Data Form 1a, Modem Data Workstation
Data Form 1b, ISDN Terminal Adapter Data Workstation
Key Mode. An Intercom Ring (ICOM Ring), an Intercom
Voice (ICOM Voice), and the first eight lines connected to the
system are assigned to all analog multiline and MLX
telephones, excluding operator positions. Two Intercom Ring
buttons are assigned to tip/ring equipment connected on an
012 or 016 module. An Intercom Ring and an Intercom
Originate Only (ICOM Orig Only) button are assigned to
tip/ring equipment connected by an MFM. No outside lines
are assigned.
4
Issue 1
February 1998
Page 4-256

Advertisement

Table of Contents
loading

Table of Contents