Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 878

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Common Administrative Procedures
UDP (Uniform Dial Plan) Routing
Console/Display Instructions
Continue to enter a restriction level for another route in the pattern or go to
! 
Step 10.
Select .
Save your entry.
! 
Select .
Return to the System Programming menu.
! 
Select four times.
UDP Digit Absorption
Use this procedure to specify how many of the digits dialed (0 through 11) by the
caller should be absorbed (not sent over the trunk) by the system when a UDP
call to a non-local extension is made on an identified route. Therefore, if the
number is dialed without a pool access code or without using a Pool button, the
dialed digits correspond to the non-local dial plan numbering. Digit absorption can
be used to modify the digits that are actually sent to the remote system.
Entries of 1 through 11 indicate that the system should not send the specified
number of digits, starting with the first digit dialed by the user.
NOTES:
1. UDP pool routes must be programmed before you assign digit
2. Do not use this procedure to overcome conflicts between local and
absorption.
remote extension numbering. Such conflicts can result in numerous
problems with system features.
Additional Information
Return to Step 8. The next route number is
displayed on Line 1.
4
Issue 1
February 1998
Page 4-408
PC

ÇÇÇÇ