Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 661

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
PRI Facilities
Telephone Number to Send
Use this procedure to assign the telephone number to send to the network when
outgoing calls are made on an ISDN line. If the person being called subscribes to
an automatic number identification service, the number indicates who is calling.
The number assigned to each channel does not have to be unique because it is
not used for routing.
The telephone number sent to the network can be the one of the following:
The extension number assigned to the calling telephone (Select
The extension number substituted into the lower order digits of a
systemwide base number (Select
The facility-based line telephone number (Select
in Step 4)
NOTE: NOTE: NOTE:
Only one base number is supported per system. In systems having non-
uniform extension numbers, for example, where there are some 3-digit
extension numbers and some 4-digit extension numbers, one base number
may not be sufficient to represent all the outside telephone numbers of all
extensions.
Summary: Telephone Number to Send
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
in Step 4)
System Manager
All
Not required
Form 3b, Incoming Trunks: DS1 Connectivity (100D module)
No digits are assigned
Up to 12 digits (any combination of 0 to 9)
No
No
Drop
Æ È Å
Drop
 Ç Ç
Type base no.
4
4
Dial base no.
Dial telephone no.
U
I
Specify type of no.
+ Type telephone no.
Issue 1
February 1998
Page 4-191
in Step 4)
Specify type of no.
Dial line no.
 U
I
+