Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 891

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Common Administrative Procedures
Night Service
Night Service with Time Set
Use this procedure to specify the time of day and the days of the week when Night
Service is to be activated and deactivated.
Enter the time of day as 4 digits, using 24-hour notation. Enter the day of the week
as a single digit (0 to 6), with 0 being Sunday. If you enter an invalid number, the
system truncates the number.
If you change the system time while Night Service is active, Night Service is
deactivated automatically and you must manually reactivate it.
Operators can override the timer and turn Night Service on and off manually. This
feature can be deactivated when out-of-the-ordinary situations occur (for
example, a midweek holiday).
NOTE: NOTE: NOTE:
For Release 2.1 and earlier, after setting Start and Stop time for Night
Service the current day of the week for Night Service must be set using the
following procedure.
If system programming information is being loaded into memory from a backup
diskette, the current day of the week must be reset.
Night Service can be turned off by using the following procedure:
NOTE: NOTE: NOTE:
The current day of the week for Night Service must be reset if system
programming information is being loaded into memory from a backup.
Summary: Night Service with Time Set
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Dial the current day of the week
Dial
System Manager
All
Not required
Form 9c, Night Service: Time Set
Not applicable
Day: 0 to 6; Time: 0000 to 2359
No
No
4
4
Issue 1
February 1998
Page 4-421