Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 594

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
Tie Trunks
Tie Trunk Seizure Type
Use this procedure to specify whether the seizure type of incoming or outgoing tie
trunk is wink, delay, immediate, or automatic.
NOTE: NOTE: NOTE:
In Release 6.0 and later systems, delay-start tie trunks should be used for
tandeming.
The following settings are recommended when T1 facilities are programmed for
tie-trunk emulation to provide special network services [such as Megacom,
Megacom 800, or Software Defined Network (SDN)]:
If Automatic Route Selection (ARS) is used for all outgoing calls and no
personal line or Pool buttons are used, assign the wink signaling type. Set
the network to wink.
If personal line or Pool buttons (pool or dial-out codes) are used for
outgoing calls, assign the immediate signaling type. Set the network to dial.
Contact your service provider for more information about the dial setting.
If Dialed Number Identification Service (DNIS) is used for incoming calls,
assign the wink signaling type. The network is also set to wink. (Setting
both ends to immediate also works.) Contact your service provider for more
information about the appropriate setting.
When DNIS is not used for incoming calls, assign the automatic signaling
type. The network is set to automatic.
Summary: Tie Trunk Type
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System Manager
All
Tie trunk idle
Form 3c, Incoming Trunks: Tie
Wink
Wink, Delay, Immediate, Automatic
No
Yes
Æ Ä Ä Å
no. Specify seizure type
or
Specify seizure type
4
4
or

 Ç Ç
Type trunk no.
Issue 1
February 1998
Page 4-124
Dial trunk