Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 716

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
BRI Facilities
Console Display/Instructions
Erase the current DN.
! 
GvrÃYYY
Enter the new DN.
! 
Dial or type [ xxxxxxxxxx ].
Save your entry.
! 
(QWHU
Select .
Return to the System Programming menu.
! 
([LW
Select three times.
Timers
Use this procedure to set timer thresholds.
! !
CAUTION: CAUTION:
The factory settings for these thresholds are standard and rarely need to be
changed. If you are not sure of the correct timer and threshold settings for
your BRI lines and trunks, check with your Lucent Technologies
representative before you make a change. Incorrect settings can cause
your BRI lines and trunks to malfunction.
If the network does not respond before the programmed time, the system takes
the appropriate corrective action.
The timers are listed below.
T200 Timer. Minimum time that the link layer waits for an acknowledgment
of a message sent from the communications system to the network.
T203 Timer. Maximum time that the link layer can remain inactive.
Additional Information
xxx = line number selected in Step x.
Press Drop.
4
Issue 1
February 1998
Page 4-246
PC
7

+
Ã
ÇÇÇ