Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 673

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
PRI Facilities
Terminal Equipment Identifier
Use this procedure to assign the link layer address of a piece of equipment
connected to each D-channel. Normally, only one piece is connected and the
system assumes that the Terminal Equipment Identifier (TEI) is 0.
! !
CAUTION: CAUTION:
The value of the TEI rarely has to be changed. Check with your Lucent
Technologies representative before changing this value.
Summary: Terminal Equipment Identifier
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Terminal Equipment Identifier
Console Display/Instructions
Select the Lines and Trunks menu.
! 
System Manager
All
Not required
Form 3b, Incoming Trunks: DS1 Connectivity (100D module)
0
0 to 63
No
No
Drop Dial new ID no.
Æ È È Ä
 Ç Ç Ç
Type new ID no.
Additional Information
4
4
Dial slot no.
 U
Type slot no.
4
Issue 1
February 1998
Page 4-203
I
+
PC
Æ