Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 841

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Common Administrative Procedures
Automatic Route Selection
In Release 6.0 and later systems, if you are setting up ARS to allow local users to
make cost-efficient calls on trunks connected to remote systems, you may wish to
check with the remote system manager to ensure that routing stipulates the most
cost-effective timing based on the rates at the remote location. If the remote
system is in a different time zone from your own, you may need to take this into
consideration as well
Summary: Start and Stop Times for Subpatterns
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure Uhiyr†
PC Procedure
Procedure: Start and Stop Times for Subpatterns
Console/Display Instructions
Select the Tables menu.
! 
System Manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
Form 3g, Automatic Route Selection Default and
Special Numbers Tables
No time is specified, thus all calls are routed according to
Subpattern A.
0000 to 2359
No
No
6ST TˆiÃ7ÃT‡h…‡
Drop Dial start time
 È 
@‡r…
no. Drop
 
Type table no.
 Ç Ç
start time
Type stop time
Additional Information
4
Dial table no.
@‡r… TˆiÃ7ÃT‡‚ƒ
 U
@‡r…
Dial stop time
 U
Type table no.
4
Issue 1
February 1998
Page 4-371
@‡r…
Dial table
@‘v‡ @‘v‡


+ Type
+
PC