Installation Options With Rack-Mount Kits, Racks, And Cabinets; Preparing To Install The Chassis - Cisco Nexus 3500 Hardware Installation Manual

Installation Options with Rack-Mount Kits, Racks, and Cabinets

Warning
Statement 1017 Restricted Area
This unit is intended for installation in restricted access areas. A restricted access area can be accessed by
skilled, instructed, or qualified personnel.
Warning Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Installation Options with Rack-Mount Kits, Racks, and Cabinets
The rack-mount kit enables you to install the switch into racks of varying depths. You can position the switch
with easy access to either the port connections or the fan and power supply modules.
You can install the switch using the following 1 (RU) rack-mount options:
• Rack-mount kit (NXK-ACC-KIT-1RU) which you can order from Cisco. This option offers you easy
• Rack-mount kit (N3K-C3064-ACC-KIT) which you can order from Cisco.
You can install the switch in the following types of racks:
• Open EIA rack
• Perforated EIA cabinet
The rack or cabinet that you use must meet the requirements listed the in
for Cabinets and Racks, on page 35
Note
You are responsible for verifying that your rack and rack-mount hardware comply with the guidelines that
are described in this doc.

Preparing to Install the Chassis

Before you can install the switch, you must verify the following:
• The installation site meets the following requirements as stated in Chapter 2:
Cisco Nexus 3500 Hardware Installation Guide
6
installation, greater stability, increased weight capacity, added accessibility, and improved removability
with front and rear removal.
• Environmental requirements for temperature, humidity, altitude, and air particulates.
• Cabinet or rack is installed and meets the requirements for the switch.
section.
Installing the Chassis
General Requirements and Guidelines