Setting Up The Authenticator - Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual

IMPORTANT: This EAP type must match the EAP type selected in
8 Clear or select the Cache user information for subsequent connections
to this network check box. The choice is yours.
9 Click OK.
10 Select to reboot if prompted.

11.3.4 Setting up the Authenticator

This section provides sample configurations for the following switches:
"Cisco® 2950 IOS" on page 272
"Cisco® 4006 CatOS" on page 273
"Enterasys® Matrix 1H582-25" on page 273
"Extreme® Summit 48si" on page 274
"ExtremeWare" on page 274
"ExtremeXOS" on page 275
"Foundry® FastIron® Edge 2402" on page 275
"HP ProCurve 420AP" on page 276
"HP ProCurve 530AP" on page 276
"HP ProCurve 3400/3500/5400" on page 278
"Nortel® 5510" on page 278
The lines that apply to 802.1X are shown in italic text. Make sure that you add this information
when configuring your switch.
®
Cisco 2950 IOS
aaa new-model
aaa authentication dot1x default group radius
aaa authorization network default group radius
dot1x system-auth-control
interface FastEthernet0/1
switchport mode access
dot1x port-control auto
dot1x timeout quiet-period 30
dot1x guest-vlan 5
dot1x reauthentication
spanning-tree portfast
!
interface FastEthernet0/2
switchport mode access
dot1x port-control auto
dot1x timeout quiet-period 30
dot1x guest-vlan 5
dot1x reauthentication
spanning-tree portfast
!
interface FastEthernet0/3
272 Novell ZENworks Network Access Control Users Guide
Step 7q on page 248.