Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 262

1b Open the following file with a text editor such as vi:
/etc/raddb/proxy.conf
1c Append the following section replacing the parameters in <> with your RADIUS servers
information: realm NULL { type = radius authhost = <RADIUS host
or IP>:<RADIUS auth port> accthost = <RADIUS host or
IP>:<RADIUS acct port> secret = <the shared secret for your
RADIUS server> }
1d Save and exit the file.
NOTE: The realm NULL section must go after the realm LOCAL section, or you can
comment out the realm LOCAL section.
2 Configure your RADIUS server to allow the Novell ZENworks Network Access Control IP
address as a client with the shared secret specified in the previous step. See your RADIUS
server's documentation for instructions on how to configure allowed clients.
3 Configure the SAFreeRADIUSConnector.conf file with the appropriate RADIUS
attributes and VLANS. See comments in the following sample file for instructions.
#
# FreeRADIUS Connector configuration file
#
#
# TO DO - Change localhost to your server's IP if this is not the built-in
FreeRADIUS server
#
ServerUrl=https://localhost/servlet/AccessControlServlet
DebugLevel=4
Debug=onUsername=nacuser
Password=nacpwd
#
# TO DO - Modify the vlan ids and names to match your switch configuration
#
#
# Use these attributes for all non-Extreme switches
#
#
# Uncomment these two sections if you want the connector to specify the normal
user vlan
# rather than specifying it for each user in the users configuration file.
#
#"HealthyRadiusAttributes"
#
#
#
#
#"CheckupRadiusAttributes"
#
#
262 Novell ZENworks Network Access Control Users Guide
Tunnel-Medium-Type := 6,
Tunnel-Private-Group-ID := 50,
Tunnel-Type := VLAN,
Tunnel-Medium-Type := 6,
Tunnel-Private-Group-ID := 50,