Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 208

12 Enter a single endpoint or list of endpoints separated by a carriage return using the endpoint IP
address, MAC address, NetBIOS name, or host name. Enter a range of IPs using a dash (-)
between or by using CIDR notation (see
NOTE: You can leave the Domains and Endpoints areas blank if you do not want to assign
domains and endpoints to this policy.
TIP: ove the mouse cursor over the question mark (?) by the word Endpoints, then click on the
CIDR notation link to see the CIDR conversion table pop-up window.
13 Click the Tests menu option to open the Tests window:
Figure 6-8
NOTE: The icons to the right of the tests indicate the test failure actions. See
"Test Icons," on page
14 Select a test to include in the NAC policy by clicking on the check box next to the test name.
15 Select a test by clicking on the test name to view the properties. For more information about
test properties, see
16 Select the test properties for this test. For more information about the specific tests, see
Appendix B, "Tests Help," on page
17 Select an action to take when an endpoint fails this test (see
Taken," on page
18 Click ok.
208 Novell ZENworks Network Access Control Users Guide
Add NAC Policy, Tests Area
215.
Section 6.4.2, "Selecting Test Properties," on page
211).
Table 16-2 on page
393.
Section 6.3.14, "Selecting Action
338).
Section 6.4.3,
213.