Table of Contents
Advertisement
Using the Built-in Novell ZENworks Network Access Control RADIUS Server for
Authentication
If you selected the Manual End-user authentication method in the
Authentication settings area of the System
configuration>>Quarantining>>802.1X window, configure Novell ZENworks Network
Access Control according to the instructions in this section.
To configure Novell ZENworks Network Access Control to handle RADIUS requests:
Add users to the RADIUS server by modifying the /etc/raddb/users file. Add user entries to
the beginning of the file in the following format:
Clear text authentication:
<user name> Auth-Type := Local, User-Password =="password"
EAP, PEAP, or MD5-Challenge authentication (the built-in windows 802.1X supplicant uses these
methods):
<user name> Auth-Type := EAP, User-Password =="password"
For example:
dave Auth-Type := EAP, User-Password =="d@9ij8!e"
11.3.2 Enabling Novell ZENworks Network Access Control for
802.1X
To enable Novell ZENworks Network Access Control for use in an 802.1X network, you need to
select it in the user interface, and make a few changes to the properties using JMS and an XML file.
Novell ZENworks Network Access Control User Interface Configuration
To enable 802.1X in the Novell ZENworks Network Access Control user interface:
Home window>>System configuration>>Quarantining
1 In the Select a quarantine method area, select the 802.1X quarantine method
radio button.
Enabling 802.1X in the User Interface
Figure 11-31
264 Novell ZENworks Network Access Control Users Guide
Advertisement
Table of Contents
