Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 459

10 Log in to the UI of the standby MS again (at this point, all UI users from the primary should be
able to log in).
11 Navigate to System configuration>>Management server>>edit network settings
12 Change the IP address to be that of the old or primary MS. See
Network Settings," on page
13 Navigate to System configuration>>Enforcement clusters and servers
14 Ensure that communication has been restored to all ESs. See
Status," on page 48.
15 Navigate to System configuration>>Management server>>edit network settings.
16 Change the IP address back to the standby MS IP (so that if and when the primary MS comes
back up, its IP address will not cause a conflict)
Settings," on page 52
52.
SeeSection 3.5.2, "Modifying MS Network
Section 3.5.2, "Modifying MS
Section 3.4.8, "Viewing ES
MS Disaster Recovery 459