Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 167

10 Click OK. The Windows Security window appears.
Windows Vista, Windows Security
Figure 5-7
11 Enter your User name and Password for the domain.
12 Click OK. A confirmation window appears once the computer has been successfully joined to
the domain.
13 Click OK to close the confirmation window.
14 You are prompted that you need to restart your Windows Vista endpoint. Click OK.
15 Click Close to close the System Properties window.
16 You are again prompted to restart your Windows Vista endpoint. Click Restart Now.
NOTE: Windows Vista endpoints are not tested until they are logged in to the domain.
Ports Used for Testing
You might need to configure some firewalls and routers to allow Novell ZENworks Network Access
Control to access the following ports for agentless testing:
137
138
139
445
TIP: See Appendix E, "Ports used in Novell ZENworks Network Access Control," on page 451
a complete description of the ports used in Novell ZENworks Network Access Control.
Allowing the Windows RPC Service through the Firewall
If end-users enable the XP SP2 Professional firewall, they need to change the configuration to allow
the agentless testing.
TIP: These firewall configuration methods can be configured using the Windows Group policy and
pushed out to all users of a Windows domain.
for
End-user Access 167