Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 197

Test name
checkHotFixes.String.5
checkHotFixes.String.6
checkIESecurityZoneSettings.String.1
checkIESecurityZoneSettings.String.2
checkIESecurityZoneSettings.String.3
checkIESecurityZoneSettings.String.4
checkIESecurityZoneSettings.String.5
checkIESecurityZoneSettings.String.6
checkIESecurityZoneSettings.String.7
checkIEVersion.String.1
checkIEVersion.String.2
checkIEVersion.String.3
checkMicrosoftOfficeMacroSecurityLevel.String.1
checkMicrosoftOfficeMacroSecurityLevel.String.2
checkMicrosoftOfficeMacroSecurityLevel.String.3
checkMicrosoftOfficeMacroSecurityLevel.String.4
checkMicrosoftOfficeMacroSecurityLevel.String.5
checkMicrosoftOfficeMacroSecurityLevel.String.6
Description
All required %s are installed.,
There are no %s installed. Run Windows Update to
install the most recent service packs and hotfixes.
You may need to run Windows Update multiple
times to install all the hotfixes.,
There was no security zone specified.,
Internet Explorer %s security zone settings are
acceptable.,
There was no security level specified.,
An invalid security level '%s' was specified.,
Could not test Internet Explorer %s security zone
settings. On Windows 2000 you must be logged in
as the same user that is currently being tested.,
The required security level for your Internet
Explorer %s security zone is %s or greater. To
change the setting, select Tools>>Internet
Options>>Security>>%s>> select the setting and
click OK. If you are using a custom setting, higher
security settings are required for:<ul>%s</ul>*
indicates an Internet Explorer 6 or later setting,
There were no Internet Explorer %s security zone
settings found.,
Unable to retrieve IE version.,
Internet Explorer version %s is acceptable.,
The required Internet Explorer browser was not
found or is not current. Install the latest version.,
The office_program and the
security_level_required parameters are required.,
The specified office_program or
security_level_required values are invalid.,
There are no Microsoft Office products installed or
the user is not logged in as the same user that is
being tested.,
All macro settings are acceptable.,
Microsoft Office %s is not installed.,
The Microsoft %s macro security level setting must
be set to %s or above. To change the security level,
open %s and do the following: Select \'Options...\'
under the \'Tools\' menu. Choose the \'Security\'
tab. Press the \'Macro Security...\' button. Select the
\'Security Level\' tab. Finally, select the security
level %s or higher.,
End-user Access 197