Setting Up Managed Devices; Installing Zenworks Linux Management On Sles 10 Ia 64 - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual

Setting Up Managed Devices

7
Before a workstation or server can be managed by ZENworks Linux Management, it must have the
ZENworks Agent installed and be registered in the Management Zone.
The following sections provide setup instructions:
Section 7.1, "Installing ZENworks Linux Management on SLES 10 IA 64," on page 53
Section 7.2, "Installing the ZENworks Agent and Registering the Device," on page 54
Section 7.3, "Setting Up the Open Enterprise Server 1 after Installing ZENworks Linux
Management," on page 57
Section 7.4, "Enabling Dell PowerEdge Support," on page 59
For more information about creating a ZENworks Agent ISO image or media and automating
installation of the ZENworks Agent, see
7.1 Installing ZENworks Linux Management on
SLES 10 IA 64
1 Back up the
/bin/rpm
2 Change the security level preference to None by using the
command.
For more information, see
Administration Guide.
3 Open any text editor and create an install script
information:
if [ ! -f /bin/rpm.orig/rpm ];then
mkdir -p /bin/rpm.orig
mv /bin/rpm /bin/rpm.orig
fi
echo "/bin/rpm.orig/rpm --nosignature \$*" > /bin/rpm
chmod +x /bin/rpm
4 Save the install script file and exit the editor.
5 Run the install script by using the
6 Install ZENworks 7.2 Linux Management with IR2on the managed device. For more
information on how to install, see
the Device," on page
7 Restore the
rpm.bak
Appendix VI, "Appendixes," on page
file by using the
cp /bin/rpm /bin/rpm.bak
"rug (1)" in the Novell ZENworks 7.27.3 Linux Management
sh ia64_72IR2_Install.sh
Section 7.2, "Installing the ZENworks Agent and Registering
54.
file by using the
mv /bin/rpm.bak /bin/rpm
command.
rug set security-level none
ia64_72IR2_Install.sh
command.
command.
Setting Up Managed Devices
115.
with the following
7
53