Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 254

13 Install the Novell ZENworks Network Access Control-to-IAS connector — The Novell
ZENworks Network Access Control IAS Connector is a DLL file that is installed on your
Windows Server 2003 machine where the IAS component is enabled. The connector is called
by IAS after the RADIUS authentication of an endpoint and during the authorization phase.
The connector contacts Novell ZENworks Network Access Control and asks for the posture of
the endpoint. Depending on the posture of the endpoint, the plug-in can return RADIUS
attributes to your switch instructing it into which VLAN to place an endpoint. The following
figure illustrates this process:
NOTE: If you have an existing Novell ZENworks Network Access Control v4.1 certificate
(compliance.keystore.cer), you need to replace it with the v5.0 certificate.
Figure 11-23
13a Copy the following Novell ZENworks Network Access Control IAS Connector files from
the Novell ZENworks Network Access Control CD-ROM (/support directory) to the
WINDOWS/system32 directory on your Windows Server 2003 machine.
support/ias/SAIASConnector.dll
support/ias/SAIASConnector.ini
NOTE: SAIASConnector.ini is installed within Novell ZENworks Network Access
Control using standard system defaults. Utilities for this such as DebugAttributes and
DebugLevel should be modified only in conjunction with technical assistance through
Novell Support (http://www.novell.com/support)
13b Import the Novell ZENworks Network Access Control server's certificate so the
connector can communicate with Novell ZENworks Network Access Control over SSL:
254 Novell ZENworks Network Access Control Users Guide
ZENworks Network Access Control-to-IAS Connector
1. On the Windows Server 2003 machine, click Start.
2. Select run.
3. Enter mmc.
or call (800) 858-4000.