Table of Contents
Advertisement
TIP: To view access status, see
Quarantined —
By NAC Policy — The endpoint has been assigned a quarantined IP address. For
example, an endpoint could have been quarantined because it failed a test or it could not
be tested.
By administrator — The administrator has selected Temporarily quarantine
for an assigned time frame.
Post-connect — The endpoint has been assigned a quarantined IP address because a post-
connect service requested the quarantine.
Blacklisted — The endpoint has been assigned a quarantined IP address because it was
designated to always be quarantined in the System
Configuration>>Exceptions>>Blacklist window.
Awaiting quarantine — A temporary state indicating that an endpoint is in the process of
being quarantined.
Granted access —
By NAC Policy — The endpoint has been assigned a non-quarantined IP address. For
example, an endpoint could have access because it passed a test, or could not be tested but
is allowed access.
Temporarily by NAC policy — The endpoint has been assigned a non-quarantined IP
address. For example, an endpoint could have access because it failed a test but was
allowed temporary access.
By administrator — The administrator has selected Temporarily grant access
and assigned a time frame.
By Access Mode — Endpoints are tested in allow all mode; however, they are always
given access to the production network.
Whitelisted — The endpoint has been assigned a non-quarantined IP address because it
was designated to always have access in the System
Configuration>>Exceptions>>Whitelist window.
Awaiting access — A temporary state indicating that an endpoint is in the process of being
allowed access.
Disconnected — Novell ZENworks Network Access Control cannot communicate with the
endpoint.
4.3 Endpoint Test Status
Novell ZENworks Network Access Control provides on-going feedback on the test status of
endpoints in the left pane of the Endpoint activity window as follows:
TIP: To view access status, see
Failed — Novell ZENworks Network Access Control shows this status after the endpoint has
failed testing. Click on the plus (+) symbol to show the test failed categories.
Passed — Novell ZENworks Network Access Control shows this status after the endpoint has
passed the test and is connected to the network.
142 Novell ZENworks Network Access Control Users Guide
Section 4.5, "Viewing Endpoint Access Status," on page
Section 4.5, "Viewing Endpoint Access Status," on page
147.
147.
Advertisement
Table of Contents
