Table of Contents
Advertisement
4.5 Viewing Endpoint Access Status
To view access status for a endpoint:
Home window>>Endpoint activity window
1 Locate the endpoint you are interested in.
2 The first column is the selection column, the second column is the Endpoint test
status column, and the third column is the Access control status column. The
icons shown in the following figure provide status:
Access Control and Endpoint Test Status
Figure 4-11
NOTE: If an endpoint is seen by two different clusters simultaneously, the endpoint state can get
lost. This could happen, for example, if you had a Training cluster and an Engineering cluster and an
endpoint that was connected in the Engineering cluster also attempted to connect by way of the
Training cluster. An error would occur in this case. Make efforts when you are configuring your
clusters to avoid allowing this condition.
4.6 Selecting Endpoints to Act on
To select endpoint to act on:
Home window>>Endpoint activity
Click a box or boxes in the first column to select the endpoints of interest.
TIP: Click the box at the top of the column to select all of the endpoints.
Endpoint Activity 147
Advertisement
Table of Contents
