Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 95

7 SSH settings:
7a Enter the User name used to log into this device's console.
7b Enter the Password used to log into this device's console.
7c To help confirm accuracy, type the same password you entered into the Password field
in the Re-enter Password field.
7d Enter the Enable mode user name that is used to enter enable mode on this device.
7e Enter the Password used to enter enable mode on this device.
7f To help confirm accuracy, type the same password you entered into the Enable password
field in the Re-enter Password field.
7g Enter the amount of time, in milliseconds, before an idle open SSH session is reset. The
default is 60000 (60 seconds) in the Reconnect idle time field.
8 Telnet settings:
8a Enter the User name used to log into this device's console.
8b Enter the Password used to log into this device's console.
8c To help confirm accuracy, type the same password you entered into the Password field
in the Re-enter Password field.
8d Enter the Enable mode user name that is used to enter enable mode on this device.
8e Enter the Password used to enter enable mode on this device.
8f To help confirm accuracy, type the same password you entered into the Enable password
field in the Re-enter Password field.
8g Enter the amount of time, in milliseconds, before an idle open telnet session is reset. The
default is 60000 (60 seconds) in the Reconnect idle time field.
9 SNMPv2 settings:
9a Enter the Community string used to authorize writes to SNMP objects.
9b Enter the OID used to re-authenticate an endpoint in the Re-authenticate OID text
field. The strings "${Port}" and "${MAC}" will be substituted for the port and MAC
address of the endpoint to be re-authenticated.
9c Select the type of the re-authentication OID from the OID type drop-down list:
INTEGER
unsigned INTEGER
TIMETICKS
IPADDRESS
OBJID
STRING
HEX STRING
DECIMAL STRING
BITS
NULLOBJ
System Configuration 95