Using Ports In Accessible Services And Endpoints - Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual

Table of Contents

Advertisement

The following describes the process in more detail:
Access mode (1) overrides the items below it in the previous list (2, 3, 4, and 5). Use the
Access mode radio buttons (System monitor>>select a
cluster>>Quarantining) to act globally on all endpoints in an Enforcement cluster.
The Temporarily quarantine for/Temporarily grant access for radio
buttons (Endpoint activity>>select an endpoint check box>>Change
access) override the items below them in the list (3, 4, and 5).
Use Temporarily quarantine for to temporarily quarantine endpoints that:
Have been designated Whitelist (System configuration>>Exceptions)
Are defined in NAC policies and have passed tests
Use Temporarily grant access for to allow temporary access to endpoints that:
Have been designated Blacklist (System configuration>>Exceptions).
Are defined in NAC policies and have failed tests
TIP: Use the Clear temporary access control status radio button to remove the temporary access or
temporary quarantine state enabled by the Temporarily quarantine for/Temporarily grant access for
radio buttons.
Endpoint testing exceptions overrides items following it in the list (4, and 5). Use
Endpoint testing exceptions (System configuration>>Exceptions) to
always allow or always quarantine endpoints that are defined in NAC policies. For example, a
NAC policy might have a range of IP addresses defined for testing, but you want to exclude
specific IP addresses within that range from the tests, so you could specify them here as
Whitelist or Blacklist.
Post-connect overrides the item following it in the list (5).
TIP: The change access button on the System Configuration>>Endpoint activity window is enabled
only when the action is possible; for example, when an endpoint or endpoints are selected.
7.2 Using Ports in Accessible Services and
Endpoints
To use a port number when specifying accessible services and endpoints (cluster
default):
Home window>>System configuration>>Accessible services
218 Novell ZENworks Network Access Control Users Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zenworks network access control 5.0

Table of Contents