Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 276

dot1x port-control auto
sflow-forwarding
!
interface ethernet 3
dot1x port-control auto
sflow-forwarding
!
interface ethernet 4
dot1x port-control auto
sflow-forwarding
!
HP ProCurve 420AP
This section shows how to configure the security settings on the 420AP so that user access may be
controlled using Dynamic VLAN provisioning.
HP ProCurve Access Point 420#configure
HP ProCurve Access Point 420(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)#no ip dhcp
HP ProCurve Access Point 420(if-ethernet)#ip address <IP of Access Point Netmask
Gateway>
HP ProCurve Access Point 420(if-ethernet)#end
HP ProCurve Access Point 420(config)#management-vlan 200 tagged
HP ProCurve Access Point 420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP ProCurve Access Point 420(if-wireless-g)#ssid index 1
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#closed-system
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-authentication-server
address <IP of RADIUS Server>
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-authentication-server
key <Shared RADIUS secret>
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-authentication-server
vlan-format ascii
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#ssid Enterprise420
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#vlan 100 tagged
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#security-suite 6 wpa-wpa2
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#enable
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#end
HP ProCurve Access Point 420(if-wireless-g)#end
HP ProCurve Access Point 420(config)#radius-accounting address <IP of RADIUS
Server>
HP ProCurve Access Point 420(config)#radius-accounting key <Shared RADIUS secret>
HP ProCurve Access Point 420(config)#radius-accounting enable
HP ProCurve Access Point 420(config)#vlan enable dynamic
Reboot system now? <y/n>: y
Dynamic WEP
Enter the same commands as the previous configuration; however, substitute security-suite
5 instead of security-suite 6 wpa-wpa2.
HP ProCurve 530AP
This section shows how to configure the security settings on the 530AP so that user access may be
controlled using Dynamic VLAN provisioning.
276 Novell ZENworks Network Access Control Users Guide