Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual page 261

17e Select the Dial-in tab.
17f In the Remote Access Permission area, select the Allow Access radio button.
17g Select the Account tab.
17h Verify that you are using Microsoft's version of the challenge-handshake authentication
protocol (CHAP) MSCHAPv2. If for some reason, you cannot upgrade to MSCHAPv2 at
this time, perform the following workaround for MSCHAPv1:
In the Account options area, select the Store password using
reversible encryption check box.
NOTE: If there are existing user accounts in your Active Directory installation when you
enable reversible encryption, the passwords must be reset (either by the user or by the
system administrator) before reversible encryption takes effect.
17i Click OK.
17j Repeat from step a for each user account.
Proxying RADIUS Requests to an Existing RADIUS Server Using the Built-in Novell
ZENworks Network Access Control RADIUS Server
TIP: For an explanation of how the components communicate, see
ZENworks Network Access Control and 802.1X," on page
To configure Novell ZENworks Network Access Control to proxy RADIUS requests to
an existing RADIUS server:
1 To configure the RADIUS server to proxy requests to your existing RADIUS server:
1a Log in to the ES as root via SSH.
Section 11.2, "Novell
236.
802.1X Quarantine Method 261