Honda Shadow TA200 2001 Manual page 91

6.
ENGINE REI\AOVALINSTALLATION
SERVICE INFORMATION
MAIN STEP REMOVAL
DRIVE SPROCKET REMOVAL
SERVICEN=ORMATION
GENERAL
6-1
6-3
6-3
ENGINE REMOVAL/INSTALLATION
DRIVE SPROCKET INSTALLATION
MAIN STEP INSTALLATION
6-4
6-10
6-10
A hoist or equivalent is required to support the motorcycle when removing and i n stalling the engine.
A floor jack or other adjustable support i s required to support and maneuver the engine.
When removing/installing the engine, tape the frame around the engine beforehand for fame protection.
The following components can be serviced with the engine i n stalled in the frame.
- Oil pump (section 4)
- Carburetor (section 5)
- Clutch/gearshift l i nkage (section 9)
- Alternator (section 10)
- I g nition pulse generator (section 16)
- Starter motor (section 17)
The following components require engine removal for service.
- Camsproket, camshaft (section7)
- Cylinder head (section 7)
- Cylinder (section 8)
- Cranksafl/transmisson (section 11)
The following components must be removed before removing the engine.
- Front side cover (section 2)
- Exhaust pipe/muffler (section 2)
- Spark plug (section 3)
- Carburetor (section SJ
- Crankcase breather tube (section 5)
- Clutch cable (section 9)
- Alternator/Neutral switch connector (section 10)
- Exciter coil line connector (section 16)
- Pulse generator connector (section 16)
- Starter motor wire (section 17)
After engine installation, adjust the following.
- Clutch cable (page 3-19)
- Rear brake light swtich (page 3-19)
- Drive chain (page 3-15)
- Throttle cable (page 3-4)
- Engine oil level (page 3-10)
6-1