Honda Shadow TA200 2001 Manual page 127

INSPECTION
Inspect the piston lor cracks or other damage.
Inspect the ring grooves for excessive wear and carbon build-
up.
Measure each piston O.D ..
NOTE:
Take measurements
23
mm (0.91 in) from the bottom, and
90° to the piston pin hole.
SERVICE LIMIT: 63.42 mm (2.497 in)
Calculate the cylinder-to-piston clearance. Take the maximum
reading to determine the clearance (Cylinder
1.0.: page 8-4).
10 mm
CYLINDER/PISTON
SERVICE LIMIT: 0.10 mm (0.004 In)
Measure each piston pin hole I . D. in an X and Y axis.
Take the maximum reading to determine I . D . .
SERVICE LIMIT: 15.04 mm (0.592 in)
Measure the piston pin 0.0. at three points.
SERVICE LIMIT: 14.96 mm (0.589 in)
Calculate the piston-to-piston pin clearance.
SERVICE LIMIT: 0.02 mm (0.001 In)
y
Measure the connecting rod small end 1 . 0 ..
SERVICE LIMIT: 15.06 mm (0.593 In)
Calculate the connecting rod small end-to-piston pin clear-
ance
SERVICE LIMIT: 0.10 mm (0.004 in)
8-5