Honda Shadow TA200 2001 Manual page 236

HYDRAULIC BRAKE
INSTALLATION
Install the brake pad (page 14-6).
Install the front brake caliper to the front fork.
Clean and apply a locking agent to the front caliper bracket
bolt threads.
Install and tighten the new front caliper bracket bolts to the
specified torque.
TORQUE: 30 N-m (3.1 kgf.m, 22 lbf-11)
Connect the brake hose to the brake caliper with new sealing
washers.
CALIPER
BOLTS
NOTE:
Be careful not to twist the brake hose.
Install and tighten the brake oil bolt to the specified torque.
TORQUE: 34 N-m (3.5 kgf.m, 25 lbf-11)
NOTE:
While tightening the brake oil bolt, align the brake hose and
with the stopper.
Refill the brake fluid (page 14-5).
..
...
j
REAR MASTER CYLINDER
CAUTION:
A void spilling brake fluid on painted, plastic or rubber parts.
Place a rag or shop towel over these parts whenever the
system is serviced.
When removing the oil hose boit, cover the end of the
hose to prevent contamination.
REMOVAL
Remove the right side cover (page 2-2).
Drain the brake fluid (page 14-4).
Remove the reservoir tank bolt and disconnect the reservoir
hose.
Remove the rear master cylinder reservoir tank.
Remove the brake oil bolt and sealing washers.
Disconnect the brake hose from the master cylinder.
Remove the cotter pin and l o wer joint.
14-20