Honda Shadow TA200 2001 Manual page 239

HYDRAULIC BRAKE
ASSEMBLY
SPRING
RESERVOR TANK
SCREWS
2 N·m (0.2 kgf·m, 1.4 l b f-ft)
'
RE _ERVOIR COVER
-
/
....-----------SET
PLATE
j-r n se , «GM
" LJD----,
MASTER CYLINDER SPRING
, · · · I
/ P ISTON
.
.::;;;:::.
.
.
· '1r1 1 lr, /
-- - .fil i t .
.>
.=
A
I
II
PUSH ROD
Replace the master piston, spring, cups and snap ring as a
set.
Replace the boot i f it i s wear, deterioration or damage.
Apply silicone grease to the boot inner surface.
Be sure that each part i s free from the dust or dirt before
reassembly.
NOTE:
Coat the master piston and piston cups with clean DOT 3 or 4
brake fluid.
Install the spring onto the master piston end.
Install the master piston/spring and washer i n to the master
cylinder.
CAUTION:
Do not allow the piston cup lips to turn inside out.
Be certain the snap ring Is firmly seated In the groove.
Install the snap ring i n to the groove in the master cylinder.
Apply silicone grease to the master piston contacting surface
of the push rod.
SNAP RING
SNAP RING PLIERS
07914 - SAS0001
CAUTION:
TOOL:
Snap ring pliers
14-23