HYDRAULIC BRAKE
Remove the push rod, master piston and spring.
Clean the master cylinder and master piston with clean brake
fluid.
NOTE:
Replace the master piston, spring, cups and snap ring as a
set whenever they are disassembled.
Be sure that each part i s free from the dust or dirt before
reassembly.
Never allow contaminants (dirt, water, etc.) to get into an
open reservoir.
SPRING
I
INSPECTION
PISTON
PUSH ROD
Check the piston cups for wear, deterioration or damage.
Check the master cylinder and piston tar scoring, scratches
or damage.
Measure the master cylinder 1.0 ..
SERVICE LIMIT: 14.06 mm (0.554 In)
Measure the master piston O.D ..
SERVICE LIMIT: 13.95 mm (0.549 in)
14-22