Honda Shadow TA200 2001 Manual page 88

EVAPRORATIVE EMISSION CONTROL
SYSTEM
EVAPORATIVE (EVAP) PURG CONTROL
VALVE REMOVAL/INSTALLATION
Remove the left side cover (page 2-2)
Disconnect the N0.4 tube, N0.5 tube and N0.11 tube.
Remove the EVAP page control valve.
Installation i s in the reverse order al removal.
INSPECTION
NOTE:
The EVAP purge control valve should be i n spected if not
restart i s difficult.
Check all fuel tank, EVAP purge control valve, and EVAP
canister hoses to be sure they are not kinked and are securely
connected.
Replace any hose that shows signs of damage or deteior-
ation.
FUEL SYSTEM
Connect a vacuum pump to the 8 mm (0.31 i n ) I.D. hose that
goes to the carburetor, Apply the specified vacuum to the
EVAP purge control valve.
SPECIFIED VACUUM: 30 mm (1.2 in) Hg
The specified vacuum should be maintained.
Replace the EVAP purge control valve i f vacuum is not
maintained.
Remove the vacuum pump and connect i t to the vacuum hose
that goes to the carburetor body.
Apply the specified vacuum to the EVAP purge control valve.
SPECIFIED VACUUM: 250 mm (9.8 in) Hg
The specified vacuum should be maintained.
Replace the EVAP purge contol valve
i f
vacuum is not
maintained.
TO CABURETOR
BODY
VACUUM PUMP
I
TO PCV CANISTER
VACUUM PUMP
I
5-19
TO CABURETOR