Honda Shadow TA200 2001 Manual page 222

HYDRAULIC BRAKE
2. Release the brake l e ver slowly and wait several seconds
after i t stops moving.
Repeat steps 1 and 2 until air bubbles do not appear in the
caliper bleeder.
Tiqhten the caliper bleeder.
TORQUE: 6 N-m
(0.6 kgf.m, 4.3
lbf.ft)
Fill the reservoir to the upper level mark with DOT 3 or 4 brake
fluid from a sealed container.
For front brake, install the diaphragm, set plate and reservoir
cover. Tighten the screws to the specified torque.
TORQUE: 2 N-m
(0.2 kgf-m, 1.4
lbf-ft)
For rear brake, install the diaphragm, set plate and reservoir
cover. Tighten the screws to the specified torque.
TORQUE: 2 N-m
(0.2 kgf.m, 1.4
lbf.fl)
FRONT:
SET PLATE
REAR:
SET
PLATE
BRAKEPADOSC
FRONT BRAKE PAD REPLACEMENT
NOTE:
Always replace the brake pads in pairs to ensure even disc
pressure.
Remove the pad pin plugs and loosen the pad pins.
14-6
PAD PINS
PAD PIN PLUGS